Description and usage:>Always follow safety guidelines and applicable regulations.
>Use only one hand to hold the tool, do not place your other hand on the air vent
Before the operation:
>Mount the right accessory for the application.
>Set the desired air temperature.
8.1 Turning on and off
>To turn on the tool, set the on / off switch to I / II position. Some smoke may be emitted later
Switch on This does not indicate a problem.
>To turn off the tool, set the on / off switch to I position and let it run for a few minutes. Then
Set the on / off switch to 0 position. Allow the tool to cool before moving or storing.
8.2 Temperature setting:
Switch on / off I / II depending on the temperature you need. The heat gun will start humming.
8.3 Stripping paint
>Mount a suitable accessory.
>Set a high air temperature.
>Turn on the tool.
>Point the hot air over the paint to remove.
>Once the paint is soft, remove the paint using a hand scraper.
1. Nozzle
2. Ventilation slots
3. ON/OFF Switch (0/I/II)
4. And add Hang hook
Voltage, electrical unit special:Voltage: 220-240 V-50HZ
Power supply: 1600W
: 350’C 300L / M
Air temperature / flow:
> 350’C 300L / M
> 350 ° C300L / M
> 500 C 500L / M.
|
|
Reviews
There are no reviews yet.